March 20, 2019
Next Steps:
- Figure out what the code does
- Get the program to recognize the controller signals
- Map out the buttons
What We Did Today:
Today we opened up the Arduino code that we found last time. We had troubles getting the code to work because we needed to download the library for it. After a little while fussing with downloading the code, we tried compiling the code again and got it to work. We then connected the pins up according to what the code said. There is data (DAT), command (CMD), clock (CLK), and another pin called SEL. When we connected up the pins to the controller, we got the controller to light up. From the serial monitor, it read "Distance: 0." Since we did not have enough time to figure out what was going on we will read through it next time.
This is the code we used and we had to download the library.
No comments:
Post a Comment